Examples Of Connections With Other Equipment; Connecting With Ios Devices; Adjusting The Input Sound - Tascam Celesonic US-20x20 Bedienungsanleitung

Examples of connections with other
equipment
Guitar
Bass Guitar
Digital recorder
Drum machine
Computer
Example using a US-20x20
CAUTION
• Before making connections, turn this unit and all equipment
to be connected off (standby).
• The phantom power switches set four input channels at a
time. Do not set phantom power to +48V when connecting
a mic that does not require phantom power.
• Before changing a phantom power switch setting, set the
LINE OUT 1–2 and PHONES 1/2 knobs to their minimum
values. Failure to do so could cause sudden loud noises from
monitoring equipment, and this could damage equipment
or harm hearing.
• Do not connect or disconnect mics when a PHANTOM
switch is set to +48V. Doing so could cause a loud noise and
might damage this unit and connected equipment.
• Set the PHANTOM switch to +48V only when using a
condenser microphone that requires phantom power.
Turning phantom power on when a dynamic mic or other
mic that does not require it is connected could damage this
unit and connected equipment.
• When using condenser mics that require phantom power
and dynamic mics together, be sure to use balanced
dynamic mics. Unbalanced dynamic mics cannot be used
when phantom power is enabled .
• Supplying phantom power to some ribbon mics will break
them. If you are unsure, do not supply phantom power to a
ribbon mic.
Drums
Headphones
Sound module
Powered speakers or amplifier
and speakers

Connecting with iOS devices

You can use a Lightning to USB Camera Adapter* to connect the
unit to an iOS device and use it as an interface with that device.
*You will need to prepare an Apple genuine Lightning to USB
Camera Adapter (sold separately).
NOTE
When connected, this unit will not provide power to the iOS
device.

Adjusting the input sound

Analog audio signals input into this device from mics, guitars,
keyboards and other audio equipment can be converted into
digital signals and transmitted to the computer via USB. In
addition, you can monitor audio signals by connecting powered
monitor speakers or headphones to this unit.
Use the various controls as necessary.
Adjust the analog input levels of the MIC/INST IN 1-2 jacks (1)
and MIC/LINE IN 3-8 jacks (2) using their gain knobs (4) so
that their signal/overload indicators (3) do not light.
To monitor the sound using headphones, connect headphones
to the PHONES 1/2 jacks (5) and adjust the PHONES 1/2 knobs
(6).
NOTE
Check the following if you cannot hear the input sounds.
o Use the PHONES 1/2 knobs on the front panel to adjust
the output levels of the PHONES 1/2 jacks.
o Use the LINE OUT 1-2 knob on the front panel to adjust
the output levels of the LINE OUT 1-2 jacks.
13
TASCAM US-20x20