Drag And Drop Route - FALK IBEX Kurzanleitung

drag and drop route

After calculating a route via the destination entry, you have the option of manually changing
the calculated route.
1. After calculating the route, tap on the fold-down button Change route
the button Drag and drop route .
2. Tap on the section of the route which you would like to change. A marking
3. Now tap (within a radius of 300 km) on the point on the map to which you would like to
move the route. The new route will be calculated and displayed. The original point is
marked .
4. Two buttons are shown which allow you to edit the route further.
delete point – the marking set previously is cancelled.
Fix point and set further point – the set marking is adopted and fixed, the new route is calculated.
Fixed points are marked with .
A fixed point can be selected again, moved or deleted at any time.
note: If the point is set away from a road, the nearest link to a segment of road is searched for and the route is calculated via this
point.
30
and then on
appears.
MY circuit
Via the function „Plan tour" you can call up the feature „My circuit".
You can now plan a circuit either from your current position or from any other point you
want, such as a POI, a city or your home address.
As a next step, you can set your desired parameters. This may for example be the desired
distance or you can also restrict the duration of the circuit. It is possible, for example, for
you to enter 20 km, or 3 hours of time.
In a next step, you are asked what activity you are performing. If you are out cycling and you
want to do a circuit, click on „Bicycle"; if you are out walking, click on „Pedestrian".
You can now select what your circuit should look like. For example, if you would prefer to
plan a more sporty route, then click on „Hilly"; if you would prefer not to climb too many hills,
then click on „Flat".
Once you have done this, you can now stipulate what type of routes you would mainly like to travel on. For example, you can set it so
that you will be guided primarily along cycle paths.
note: Setting the preferred transport routes means that correspondingly selected transport routes will be given priority in the route
calculation. For example, if „Avoidroad traffic" is selected, the device will mainly calculate a route which tends not to run along roads.
It is of course not possible to prevent this entirely because sometimes the use of roads is unavoidable to continue the route of a tour.
31