Initial Settings; Outdoor Navigation View - FALK IBEX Kurzanleitung

initial SettingS

1. Start the device.
2. Select the language you want.
3. Select the country map you want.
4. Acknowledge the note on calibration of the
sensors by clicking on „OK".
5. Enter your home address. You could then
select this at a later date with just one click
to be navigated back home directly. You can
change the address which is entered at any
time via
„Settings > System/General > Set Home".
6. Switch to the main menu.
7. Carry out the calibration of the compass via „Settings > System/General > Calibrate Compass" and follow the instructions of
the device. You must repeat the calibration when the compass needle is shown in grey in the title bar of the map view.
8. Carry out the calibration of the barometer via „Settings > System/General > Calibrate Compass" and follow the instructions of
the device. Please note that, to obtain optimum values, you should carry out the calibration process again before each
walk/bike ride.
26

outdoor naVigation View

Compass
Mode of transport
GPS signal quality
Info field
Next-but-one
manoeuvre
Next
manoeuvre
Main menu
Altitude profile
Info field Information about the calculated route. Tap on the field
to select other information.
Rapid access menu Offers faster access to specific functions.
Click on map: If you tap on a point on the map, the point is marked with a pin and the
address or position is displayed.
If you tap on „Actions", you could for example navigate to the marked point or save the
position.
Battery status
Info field
Next street
Map
Zoom button
Position
Current street
Rapid access menu
27