Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing Steam; Frothing Milk - Krups ESPRESSERIA AUTOMATIC PREMIUM EA69 serie Handbuch

Vorschau ausblenden Andere Handbücher für ESPRESSERIA AUTOMATIC PREMIUM EA69 serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
6

PREPARING STEAM

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up
liquids. As you need a higher temperature to produce steam than to make an espresso, the
appliance runs an additional pre-heating phase for steam.
While the screen displays the drink selection menu, press the "steam" key
that the appliance is being pre-heated. Once the pre-heating phase has been completed, a message will
ask you to place a container under the steam nozzle. Press the "steam" key
steam. A little water will be produced first and then steam will start. Use the same key to stop steam ge-
neration.
!
Caution!
Be careful, because the cycle does not stop immediately.

6.1 Frothing milk

!
Note:
We recommend that you use very cold, fresh pasteurised or UHT milk that has been recently
opened. Do not use untreated milk. After the steam function has been used, the nozzle will be hot, and we
recommend that you wait for a few moments before handling it.
h
Check that the steam
Pour the milk into your
nozzle is correctly fit-
milk jug. Only half fill it.
ted.
Immerse the nozzle in
the milk.
To remove any
Let the steam
remaining milk from the
escape for at least 10
steam nozzle, place a
seconds and then again
container under the
press the "hot water"
nozzle and press the
key
"hot water" key
.
process.
!
Note:
To interrupt the steam function, just press any key. If the nozzle is blocked, clean it out with a fine needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
Press the "steam"
key
and follow the
instructions on the
screen.
You can remove the steam nozzle for thorough cleaning. Wash it using a brush
with water and a little non-abrasive washing up liquid. Rinse and dry it.
Before re-fitting, make certain that the air inlet holes are not clogged by milk
residues. Clean out the holes with a needle if necessary.
to stop the
. A screen will inform you
again to start generating
Once your milk is frothy
Again press the
enough...,
"steam" key
the cycle. Be careful,
because the cycle does
not stop immediately.
ENGLISH
to stop
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis