Herunterladen Inhalt Inhalt Diese Seite drucken

Installation - Velleman HAMGSM133 Bedienungsanleitung

Duplex fernbedienungsmodul 2 in/2 out
Vorschau ausblenden Andere Handbücher für HAMGSM133:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

5.
Overview
Refer to the illustrations on page 2 of this manual.
1
power supply
2
USB interface (optional)*
O1
output 1
O2
output 2
LD1
relay 1 active
LD2
relay 2 active
LD3
input 1 active (logical condition reached)
LD4
input 2 active (logical condition reached)
LD5
GSM network connection status
U1
transmit LED
U2
receive LED
6.

Installation

When applicable install the USB interface HAMGSM133/USB [2] (not included). The mini USB connector
must be on top.
Insert a valid SIM card [3]. Make sure the PIN code of the SIM card is disabled. Use a normal mobile
phone for this.
Connect the antenna to the antenna connector [4].
Make all necessary connections (I1, I2, O1, O2). Only connect a SELV (Safety Extra Low Voltage) load
to the outputs. Tension applied to the contacts of each relay must not exceed 60Vdc; switching current
on the relays must not exceed 10A (short peak). The maximum tension applied to the digital inputs is
32Vdc.
Connect the power supply [1] (not included). Use a stabilized current-limited power supply (not
included) providing 9~32Vdc and at least 500mA current (able to deal with absorption peaks of 1A).
Note that the centre tip is positive.
Close the housing (not included).
7.
Introduction
The HAMGSM133 is a bidirectional remote control module capable of remotely controlling two relays
(in monostable or bistable mode) through the use of special SMS commands sent from any mobile
phone.
Memory for up to 8 telephone numbers to which SMS and/or ringtones can be sent when input status
changes (master list).
It is also possible to use the HAMGSM133 as a gate control receiver controlled by up to 200 entered
phone numbers (gate control list).
To facilitate programming, it is possible to connect a USB interface module and manage the device via
PC through downloadable software. This module must be purchased separately; order code
HAMGSM133/USB.
8.
Configuration
There are 3 ways to set up the device:
through call (only at start-up)
through SMS
through USB (USB interface required, not included).
8.1
Through call (only at start-up)
When the device is supplied with power, "LD5" will immediately flash at 1 Hz frequency. The HAMGSM133 will
try to connect to the GSM network. When connected, "LD5" will briefly flash every 2 seconds. After the system
initialization (which may take several seconds), the device alternately illuminates yellow LEDs "LD3" and "LD4"
to indicate the "configuration call" on hold mode for 3 minutes. If during this time the unit receives a call, it
stores the caller's number (to which reply SMS will be sent) in the first memory location and LD3 and LD4 turn
off.
V. 02 – 15/05/2012
HAMGSM133
3
SIM card (not included)
4
antenna connector
I1
input 1
I2
input 2
U3
mini USB connector
7
* HAMGSM133/USB, not included
©Velleman nv

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis