Inhaltsverzeichnis
Werbung
connected to a Thunderbolt 3 port on your host laptop. However, Windows 7 users will
need to download and install the required drivers. Follow the instructions below to
install the docking station.
Power the docking station
1. Select the appropriate power cord for your region and connect it to the power
adapter.
2. Connect the power adapter to an AC electrical outlet and then to the docking
station's DC IN (power-input) port. The docking station should now be receiving
power.
Connect the docking station
1. Connect your external display(s) to the docking station (example, DisplayPort or
Thunderbolt 3 displays).
Note: See the "Configure a display device" section for dual-display configuration
requirements.
2. Connect your peripherals to the docking station (example, USB devices, RJ 45
network).
3. Connect the provided Thunderbolt 3 cable to a Thunderbolt 3 port on your host
laptop and to one of the Thunderbolt 3 USB-C ports on the docking station.
Notes:
• You can connect either of the docking station's Thunderbolt 3 ports to your host
laptop.
• When the docking station is connected to your host laptop, a charging icon may
appear on your laptop's screen. The docking station is only outputting 15-watts of
power to your host laptop. The provided power is only sufficient enough to charge
your laptop if the laptop is in a sleep state, and charging will require an extended
time period.
Driver installation
Install drivers in Windows 10 or Windows 8 / 8.1, or macOS 10.12 (Sierra)
When the docking station is powered and you connect it to your laptop, the required
drivers will install automatically.
You may see a pop-up message requesting permission to allow the docking station to
connect to your computer. If a pop-up message appears, do the following:
1. Click on the pop-up message.
2. On the following prompt, click Always Connect in the drop-down list.
3. Click OK. Follow any other on-screen instructions to complete the installation.
Instruction manual
5
Werbung
Inhaltsverzeichnis
