Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Before you start using your high pressure washer
DE
A
EN
CS
Operation elements
SK
10. Click&Clean Powerspeed nozzle
11. Foam sprayer
12. Nozzle cleaning tool
13. Accessory storage
14. Model tag
15. Trolley handle
16. Holder for hose/electric cable
17. Hexagon key for handle and bracket mounting
18. Wheel brackets
19. Wheels
20. Wheel caps
3.1 Mounting of trolley handle and wheels
3.2 Mounting of quick coupling
26
See the pictorial quick reference guide – unpacking.
Illustration shows the operation elements and how to prepare your machine for use.
1. Start/stop switch
2. Water inlet with fi lter
3. High pressure connection
4. High pressure hose
5. Electric cable
6. Click&Clean spray lance
7. Spray handle with lock (7a)
8. Click&Clean Tornado nozzle (AQUA 1100)
9. Click&Clean Tornado PR nozzle (AQUA 1200)
Mounting of trolley handle
A1
Place the trolley handle (15) on the machine.
A2
Secure the handle by mounting the 2 screws using the enclosed hexagon key (17).
Mounting of wheel brackets
A3
Place the wheel brackets (18) on the machine.
A4
Secure the wheel brackets by mounting the 2 screws, using the enclosed hexagon key.
A5
Place the wheels (19) on the wheel axel – push into position – you should hear a click
when the wheels are in correct position.
A6
Secure the wheels by mounting the wheel caps (20) – you should hear a click when the
wheel caps are in correct position and the wheel is secured.
A7
When mounting the quick coupling for the fi rst time, check that the factory fi tted fi lter is
positioned in the water inlet pipe.
A8
Screw the quick coupling tight on to the water inlet (2).
The inlet fi lter must always be fi tted in the water inlet pipe to fi lter out sand, lime stone and other
impurities as these will damage the pump valves. The fi lter is factory fi tted.
If the fi lter is removed this will invalidate the guarantee.
IMPORTANT!
Original Instructions
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
