Danfoss TP5001 Handbuch Seite 6

d) Press PROG to move to the next preset time
GB
and temperature (Event 2).
e) Repeat steps b, c, & d to programme the
remaining weekday events.
For Days 6-7 (weekends)
Press PROG until the fi rst preset time and
temperature (Event 1 Days 6-7) appears in display.
Repeat steps b, c, & d above to programme the
remaining weekend events.
Changing the preset programmes in 24 hour mode
Press PROG until the fi rst preset time and
a)
temperature (Event 1 for all days of the week)
appears in display.
Use the + and - buttons to adjust the TIME
b)
(press and hold to change in 10 min increments).
Use the Λ and V buttons to adjust the required
c)
TEMPERATURE.
Press PROG to move to the next preset time
d)
and temperature (Event 2).
e) Repeat steps b, c, & d to programme the remaining events.
Changing preset programmes for AB programming
(Installer setting must be in 5/2 day mode)
Press and hold PROG and V for 3 seconds. The
display will change to the fi gure opposite. This
will take you into User Advanced Programming
option 1.
Use Λ and V keys to enable or disable the function
(1=enabled, 0=disabled).
Press PROG for 5 seconds until the display changes
and the colon in the display fl ashes to confi rm that
you are in RUN.
Press PROG once, the display will change to show
the default days assigned to programme "A" (days
1, 2, 3, 4 & 5).
6