Kompernass WK 8 A1 Bedienungsanleitung Seite 25

Sensitivity motion sensors
Set the sensitivity of the front motion sensor
and environments with little interference, such as branches blowing
in the wind, select "High". Select "Medium" for outdoor spaces and
environments with a normal amount of interference, and select "Low"
for environments with a high level of interference. Temperature can
also affect the sensitivity. The "High" setting is suitable for warm
ambient temperatures, whereas "Low" should be selected for cold
environments.
NOTICE
► The sensitivity of the front motion sensor
medium. This setting is suitable for most applications.
► Note that the setting of "high" increases the likelihood of the
camera being triggered unintentionally. The setting "Low" can
lead to small animals not being detected at all.
Target recording time
Select "On" if the camera should only be active during a certain time
period. The recording time set in this menu is also valid for time lapse
recordings. In the screen menu that subsequently appears, you can
then set the start and end time for the active phase:
♦ Press the /
phase.
WK 8 A1
Set
target recording time
Start:
Hr:Min
buttons to set the hour for the start of the active
5
here. For inside spaces
5
is factory-set to
Stop:
Hr:Min
GB │ IE │ NI │
21 ■