Operation - SEVERIN LS 0671 Bedienungsanleitung

■
Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
■
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
■
This appliance is intended for domestic use
only and not for commercial applications.
■
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.

Operation

Make sure the appliance is used on dry hair
only.
- Insert the plug into a wall socket.
- Use the On/Off tip switch to turn the curler
on.
- Use the temperature-control buttons to set
the desired level, observing the above
instructions. Pre-heating starts and the
selected temperature is shown in the in the
display.
- The indicator light flashes during pre-
heating. Once the selected temperature
has been reached, a beep signal is heard
and the indicator light stops flashing and
shows constant red.
■
During the heating phase, the appliance
should be left on a firm, heat-resistant
surface.
- Divide the hair into separate strands, grip
the end of a strand with the clamp and curl
it up to the hairline.
The integrated swivel makes it easy to use
the curler in this way.
- Hold the hair curled up for a few seconds,
then open the clamp and remove the curler
gently from the hair by turning it.
■
Make sure the hot parts of the curler are
kept away from the scalp.
- Let the hair cool down sufficiently before
brushing it out.
- Switch the appliance off after use. When
the indicator light goes out, remove the plug
from the wall socket.
■
Do not place the curler on any surface
sensitive to heat during or immediately after
use.
Temperature selection
The appliance offers 4 temperature settings:
100° C, 130° C, 160° C and 200° C. To
avoid damage to the hair, always start with a
low temperature setting. Begin with a
temperature setting of 100° C for fine hair, or
160° C for normal or thicker hair. If the hair
can be shaped at that setting, no further
increase in temperature is necessary, as the
optimum setting has already been reached.
Automatic switch-off
The appliance has an automatic switch-off
which takes effect after about 60 minutes.
Before this automatic switch-off, a multiple
beep signal is heard. A graphic bar on the
right-hand side of the LCD display shows the
elapsed operating time, one bar being added
after each 10 minutes' operation.
General cleaning and care
■
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
■
To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
■
Do not use abrasives or harsh cleaning
solutions.
- If necessary, the housing may be wiped
with a dry lint-free cloth.
Disposal
Do not dispose of old or defective
appliances in domestic garbage; this
should only be done through public
collection points.
10