Error Description - Vivanco 33899 Bedienungsanleitung

Follow the indications of the instructions of use
of the device to be charged.
1. Be sure that the device to be charged is
compatible with Power Bank
(compare identification plate).
2. Connect the USB cable with the device to
be charged.
3. Connect the USB cable with Power Bank.
(big connection pos. 4).
Press the operating button shortly (pos.1).
The charging process starts and the LED
(pos. 5) show the charging status."
4. Perform the disassembly in reverse order.
C) Contemporaneous charging of Power
Bank and of a device
It is posible to contemporaneously charge
Power Bank and a connected device.
If the capacity of Powerbank is exspent, the
charging of the connected device switchs off
until Power Bank reaches again a charging
level of at least 30%.
D) Display of the capacity of Power Bank
Press the operating button (pos. 1) shortly. The
LEDs (pos. 5) of the capacity display indicate
the charging status.
The capacity display switches off automatically
after a few seconds.
• 4 LEDs are illuminated:
Power Bank is fully charged
• 1 LED is illuminated:
Power Bank is charged on approx. 25%
• LED 1 flashes all 1s approx.:
remaining capacity of 1% approx.
Questions and answers

Error description

The connected device
is not being charged
Power Bank is not being
charged
LED light does not switch
on or off
Embedded LED light.
Power Bank has an embedded LED light
(pos. 3)
1. Switch on: Press the operating button
(pos. 1) more than 3 seconds.
2. Switch off: Press the operating button
(pos. 1) more than 3 seconds.
requirements and the other relevant regulati-
ons of the guideline 2004/108/EC.
This device shall not be disposed with
household waste. Please hand it over to any
collection point for electric devices in your
community or district. This ensures that old
devices are recycled professionally,
economically and prevents potential advert
affects on the environment and human health.
Packing material shall be recycled. Please do
not dispose with household waste and act
according to local disposal regulations.
Possible causes
Bad cable contact
Power Bank not charged
Bad or no connection
of the charging cable
can't be charged through USB
or the charging current is too low of your device to be
Operating button pressed
too shortly
Hereby Vivanco GmbH declares that
PB 5200 BL complies with the essential
Disposal of the device
Disposal of packing
Measures
Check cable connection
Charge Power Bank
Check cable connection
Check with the instructions
charged
Press operating button
more than 3 seconds
5