IFM Electronic AC1376 Montageanleitung Seite 14

O System setup (Setting of the gateway device)
O System info
O Master setup (AS-i master flags)
O Slave setup
14
∇ Input of the password to enable changes in the
system configuration
∇ Update of the gateway firmware (special pro-
gramming software required)
(Device information)
∇ Hardware and firmware version numbers of this
gateway
∇ Serial number of this gateway
∇ Current / maximum PLC cycle time
∇ Reading of the current AS-i configuration (config all)
∇ Changeover to the projection mode: configurati-
on of the AS-i system
∇ Changeover to the protected mode: standard
mode (the master monitors the configuration)
∇ Deactivation of the automatic AS-i slave addres-
sing in the protected mode
∇ Deactivation of the AS-i reset when exiting the
projection mode
∇ Display of the config error counter of the connec-
ted AS-i system
∇ Reset of the config error counter
∇ Display of the percentage fault rate of the
connected AS-i system
(Details about the connected AS-i slaves)
∇ Digital or analogue inputs/outputs of the connec-
ted AS-i slaves
∇ Current and projected parameters of the connec-
ted AS-i slaves
∇ Current and projected I/O and ID codes of the
connected AS-i slaves
∇ Message faults in the communication to the
connected AS-i slaves