Operating And Indicating Elements - IFM Electronic AC1376 Montageanleitung

Supply the AS-i DP gateway with a 24 V DC voltage (20...30 V PELV),
e.g. from the 24 V power supply DN2011 of ifm electronic. The
connection is made to the terminals +24 V and 0 V.

Operating and indicating elements

Information concerning the state of the masters and the connected
system is given via three diagnostic LEDs on the AS-i DP gateway.
• LED PWR/COM lights:
• LED PWR/COM flashes: AS-i voltage present, but no slave was
• LED PROJ lights:
• LED PROJ flashes:
• LED CONF/PF lights:
• LED CONF/PF flashes:
• LED Profibus DP lights:
10
AS-i voltage present, at least one slave
was detected
detected correctly
Projection mode active, the configuration
monitoring is deactivated
Projection mode active, changeover to
protected mode not possible as a slave
with the address 0 is connected
Projected and current configuration do
not match
Periphery fault on at least one connected
slave
Bus error Profibus DP