Chime Selection; Chime Fuction; Integration Into An Existing Door Bell System - REV Ritter 14904 Bedienungsanleitung

the receiver reacts without fail to the transmitter's signals. Open
the cover of the battery compartment on the transmitter ➁ and
turn the switch ➂ to a position between 1 and 16 chosen by you.
The switch ➂ on the receiver A has to be set the same position.
TIP: Test the required function before final installation at your
chosen installation point (see text no. 9).

5. Chime selection

You can set required chime using the selector switch ➃ :
TIP: If you are using further transmitters you can install differing
signals using chime selection.
6. Chime function
The radio-controlled chimes can be used upon completion of co-
ding (see text no. 4) and installation of the transmitter (fastening
materials are included with the set). The transmitter  is spray-
water protected to IP 44 and can therefore be used outdoors.
When the button ➅ is pressed, the chimes sound briefly with the
selected melody. Using the switch ➄ it is possible to switch the
chimes off or adjust their volume.

7. Integration into an existing door bell system

The radio-controlled chimes are suitable for integration into an
existing door bell system. Two operating formats are available for
this:
You have an existing door bell system with transformer and would
like to operate the radio-controlled chimes in another room paral-
lel to the existing chimes (illus.
☛ Connect the contacts A and C of the transmitter  parallel to
(a) 2-tone chimes
(b) 3-tone chimes
(c) Westminster chimes
II
)
15