Safety Warnings - Ferm HDM 1022 Originalbetriebsanleitung

EN
RotaRy HammeR
thank you for buying this Ferm product.
By doing so you now have an excellent product,
delivered by one of Europe's leading suppliers. All
products delivered to you by Ferm are
manufactured according to the highest standards
of performance and safety. As part of our
philosophy we also provide an excellent customer
service, backed by our comprehensive warranty.
We hope you will enjoy using this product for many
years to come.

Safety warnings

WARNING Read the enclosed safety
warnings, the additional safety warnings
and the instructions. Failure to follow the
safety warnings and the instructions may
result in electric shock, fire and/or serious
injury. Keep the safety warnings and the
instructions for future reference.
the following symbols are used in the user
manual or on the product:
Risk of personal injury.
Risk of electric shock.
Immediately remove the mains plug from
the mains if the mains cable becomes
damaged and during cleaning and
maintenance.
Wear safety goggles. Wear hearing
protection.
Double insulated.
additional safety warnings for hammer drills
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Wear safety goggles, hearing protection and if
necessary other protective means, such as
safety gloves, safety shoes, etc.
• Always hold the machine with two hands.
4
• Make sure that the workpiece is properly
supported or fixed.
• Before use, always check walls, floors, or
ceilings for the presence of hidden wiring and
pipes.
• Only use accessories that are suitable for use
with the machine.
• Only use accessories with the correct
dimensions.
• Inspect the accessories before each use. Do
not use accessories which are bent, cracked,
or otherwise damaged.
• Always use the auxiliary grip to reduce the risk
of loss of control. Risk of personal injury.
• Hold the machine by the insulated gripping
surfaces where the accessory may contact
hidden wiring or the mains cable. If the
accessory contacts a 'live' wire, the exposed
metal parts of the machine can also become
'live'. Risk of electric shock.
• After use, do not touch the tip of the
accessory.
electrical safety
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/13A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
• The wire which is coloured blue must be
. If you use a
2
Ferm