HEINE ML4 LED Serie Bedienungsanleitung Seite 12

With HEINE S-Guard
®
• Before putting on the loupes, select your inter-pupillary distance (PD) or an average
value on the scale. Unscrew the retaining screw and slide the eyepieces to one side
symmetrically.
• Unscrew the fixing screw (4) and locate the nosepad on the bridge of the nose.
• Adjust the eyepieces so that they nearly touch the protective lenses.
• Shine the ML4 LED onto an object at your normal working distance and adjust the
eyepieces so that the object is centred in both eyepieces. After adjustment, re-tighten
the screw (4).
The loupes are correctly adjusted when you see a clearly-defined, round, shadow-free
field of view. The slider (5) allows up or down adjustment of size of the light field.
HEINE LED LoupeLight and HEINE
®
• Connect the LED Light to HEINE
• Switch on the LED Light and adjust vertically the
light housing such that the illumination is centred
on the area to be examined.
• Turing the swivel lever at the mPack LL allows
continuous adjustment of the brightness.
• Fasten the cable on your clothes using
the support clip provided (see Fig. 11).
LED LoupeLight
• Adjust the binocular loupe for the intended application. Be sure the eyepieces are
positioned as symmetrically as possible on the optics holder (take off the loupe and
check this), as otherwise the spot of light will appear shifted to the side.
LED MicroLight
• In order that the LED MicroLight remains in place in every gradually and freely selectab-
le position, it may be necessary to retighten the screws using a screwdriver (see Fig. 13).
Fig. 13 Tighten the screws
12/72
mPack LL.
®
1
med 0714
LED MicroLight
®
Fig. 11 Cable fastening with
• LED LoupeLight on loupe mount with
HEINE i-View
can be attached to one end (1) of the loupe
mount so that the binocular loupe can be
swivelled independently of the light
(only HR/HRP Loupes).
Fig. 12 Using the steri-lever
2014-12-02
support clip
. If required, a steri-lever (12)
®