Cleaning And Maintenance; Technical Data - Kinzo 25C5030 Gebrauchsanweisung

Using the steel wire brush (fig. B)
I Use the steel wire brush (23) for cleaning, removing rust and
polishing on hard metal.
Checking and replacing the carbon brushes (fig. A)
The carbon brushes must be checked on a regular basis.
Remove the carbon brush holders (3) and clean the carbon brushes.
I
In case of wear, replace both carbon brushes at the same time.
I
Mount the carbon brush holders.
I
I After mounting new carbon brushes, let the machine run at no load
for 15 minutes.

CLEANING AND MAINTENANCE

The machine does not require any special maintenance.
I Regularly clean the ventilation slots.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No load speed
Collet size
Weight
Level of sound pressure measured according to EN 50144:
L (sound pressure)
pA
L (acoustic power)
WA
50
25C5030_20.p7
Use only the correct type of carbon brushes.
Take appropriate measures for the protection of hearing.
50
25C5030
V 230
Hz 50
W 135
-1
min 10,000 - 33,000
mm 1.0-3.0
kg 0.5
25C5030
dB(A) 77.5
dB(A) 90.5
25C5030
04-06-2004, 15:29