Control Unit - JBSystems usb 2.2 Mk2 Bedienungsanleitung

ENGLISH
5. USB 2 connection: this is the second (type-A) USB-connection, used to connect any USB mass storage
device that was formatted in FAT or FAT32. By default this input is used to connect a hard disk.
6. CONTROL connector: connect this connector to the control unit, using the supplied mini-DIN8 cable.
7. AUDIO outputs: Output for the audio signals from the player. Use the supplied cinch/cinch cable to
connect this output to a CD/line input of your mixing unit.
8. MAINS input: connect the player to the AC mains, using the supplied power-cord.

CONTROL UNIT

1. TACTILE JOG-WHEEL: The jog-wheel on this player has 2 parts:
 Tactile center part: to match the vinyl feel as close as possible and largely improve scratch
performance. With the
Check the description of the JOG MODE button (2) for more information.
 Outer ring: rubber coated part of the jog wheel which is not touch sensitive. Regardless of the
selected wheel mode the outer ring can be always be used for pitch bending
2. JOG MODE button: toggles between 2 different modes for the tactile jog-wheel. The tactile center part
and outer ring behave differently:
 VINYL-mode: used for scratching of any CD or MP3 file.
 Tactile center part: During playback, the music stops immediately when you touch the jog-
wheel: playback speed and direction are now fully controlled by the movements of your hand.
In pause mode you can easily set a new cue point.
 Outer ring: During playback you can use the outer ring for pitch bending to synchronize the
beats of 2 tracks. In pause mode you will hear the typical very small loops that give you the
possibility to set a cue point with 1frame (1/75seconds) accuracy.
JB SYSTEMS
®
JOG MODE button (2) you can change the behavior of this central part.
4/82
OPERATION MANUAL
USB2.2 MK2