Installation - Mantis XP Montageanleitung

INSTALLATION

1. First, you will need to understand that your Mantis
has an inner and outer set of tines on each side of the
tiller as shown in Figure 3.
2. Make sure the tiller is turned off.
3. Remove the retaining pins from the outer set of tines
(Figure 4) and remove the outer tines.
4. Only after you have removed the outer set of tines,
remove the retaining pins from the inner tines. Remove
the inner tines from the transmission axle. (Figure 5)
5. Place one set of inner aerator tines onto the left side
Figure 3
Inner Tines
Outer Tines
XP
®
Figure 4
Figure 5
Übersetzung der originalen Bedienungsanleitung
Mantis XP Lawn Aerator • mantis.com
®
axle of the transmission. Install the tine retaining pin.
Repeat for the other side.
6. Place one set of outer aerator tines onto the left side
axle of the inner aerator tines. The "D" shaped hole of
the tine hub should be to the outside. Insert the tine
retaining pin. Repeat for the other side. Make sure to
match the orientation of the outer aerator tines with
the orientation of the inner tines.
DO NOT reach your fingers and/or hand between
the tine blades. DO NOT attempt to remove
the inner set of tines until you have first
removed the outer set of tines.
Original Operating Instructions
Traduction des instructions originales
p/n 410733 Rev. B 4.12.18
© 2018 Schiller Grounds Care, Inc. All Rights Reserved.