Control Test; Before Running Your Ten-Sct; Li-Po Charger Safety Precautions And Warnings - TLR Ten SCT Bedienungsanleitung

Control Test

Perform a control test with the vehicle wheels off the ground. If the tires
rotate after the vehicle is powered-on, adjust the "TH. Trim" knob located to the
lower left of the steering wheel until they stop. To make the wheels move forward,
pull the trigger. When moving forward, the wheels should track in a straight line
without any steering wheel input. If not, adjust the "ST. Trim" so the wheels track
in a straight line without having to turn the steering wheel.

Before Running Your TEN-SCT

1. Break in the differentials. While holding the chassis with only the left side
tires firmly on the ground, give the car about 1/8 throttle for 30 seconds.
The right side tires should spin freely during this time. Repeat this with only
the right side tires firmly on the ground, allowing the left side tires to spin
freely. Repeat this 2–3 times.
2. Check for free suspension movement. All suspension arms and steering
components should move freely. Any binds will cause the car to handle
poorly.
3. Set the ride height. Set the ride height of your truck with all components
installed so that the bottom of the chassis is 29mm from the ground in the
front and 28mm in the rear by adjusting the shock collars.
4. Set the camber. Adjusting the camber tie rod length changes the camber.
Set the front tires to have 0 degrees of camber at ride height. Set the rear
tires to have 2.5 degrees of negative camber at ride height.
5. Set the front toe-in. Adjust the steering tie rods so that when the servo
is centered on the transmitter, the front tires are both pointing straight.
6. Charge the LiPo receiver battery pack. Always charge the battery pack
as per the battery and/or charger manufacturers' instructions.
7 Set the transmitter steering trim. Follow the instructions to set the steering
trim/subtrim so that the vehicle drives straight with no input to the steering.
8. Set the transmitter steering endpoints. Follow the instructions in the
transmitter instruction manual to set the endpoints so that the servo
achieves full steering upon reaching full input from the transmitter.
WaRNING: Failure to exercise caution while using this
product and comply with the following warnings could result in
product malfunction, electrical issues, excessive heat, FIRE,
and ultimately injury and property damage.
TLR TEN-SCT RTR • INSTRuCTIoN maNuaL
Forward

Li-Po Charger Safety Precautions and Warnings

• Never leave the charger and battery unattended during use.
• Never attempt to charge dead, damaged or wet battery packs.
• Never attempt to charge a battery pack containing different types
of batteries.
• Never allow minors to charge battery packs.
• Never charge batteries in extremely hot or cold places or place
in direct sunlight.
• Never charge a battery if the cable has been pinched or shorted.
• Never connect more than one battery pack to this charger at a time.
• Never connect the charger if the power cable has been pinched or shorted.
• Never attempt to dismantle the charger or use a damaged charger.
• Never reverse the positive and negative terminals.
• Always use only rechargeable batteries designed for use with this type
of charger.
• Always inspect the battery before charging.
• Always keep the battery away from any material that could be affected
by heat.
• Always monitor the charging area and have a fire extinguisher available
at all times.
• Always end the charging process if the battery becomes hot to the touch
or starts to change form (swell) during the charge process.
• Always disconnect the battery after charging, and let the charger cool
between charges.
• Always terminate all processes and contact Horizon Hobby if the
product malfunctions.
WaRNING: Never leave the charger unattended, exceed maximum
charge rate, charge with non-approved batteries or charge batteries in
the wrong mode. Failure to comply may result in excessive heat, fire
and serious injury.
CauTIoN: Always ensure the battery you are charging meets the
specifications of this charger and that the charger settings are correct. Not
doing so can result in excessive heat and other related product malfunctions,
which can lead to user injury or property damage. Please contact Horizon
Hobby or an authorized retailer with compatibility questions.
EN
Brake
5