Dust/Chip Extraction - Bosch PSR Easy LI Originalbetriebsanleitung

OBJ_BUCH-2483-004.book Page 35 Wednesday, November 25, 2015 8:08 AM
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
Hold the rear sleeve 3 of the keyless chuck 1 tight and turn the front sleeve 2
in rotation direction , until the tool can be inserted. Insert the tool.
Hold the rear sleeve 3 of the keyless chuck 1 tight and firmly tighten the front
sleeve 2 by hand in rotation direction , until the locking action (click) is
heard. The drill chuck is locked automatically.
The locking is released again to remove the tool when the front sleeve 2 is
turned in the opposite direction.

Dust/Chip Extraction

 Dusts from materials such as lead-containing coatings, some wood types,
minerals and metal can be harmful to one's health. Touching or breath-
ing-in the dusts can cause allergic reactions and/or lead to respiratory in-
fections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered as carcinogenic,
especially in connection with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may only be worked by spe-
cialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the materials to be
worked.
 Prevent dust accumulation at the workplace. Dusts can easily ignite.
Bosch Power Tools
English | 35
1 609 92A 1ML | (25.11.15)