OBJ_BUCH-2483-004.book Page 34 Wednesday, November 25, 2015 8:08 AM
34 | English
Assembly
Battery Charging (see figure A)
Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Note: The battery supplied is partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer ro-
tates.
Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows charg-
ing only within a temperature range of between 0 °C and 45 °C. A long bat-
tery service life is achieved in this manner.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 13 is
plugged into the socket 12 on the bottom of the handle.
The battery charge-control indicator 6 indicates the charging progress. Dur-
ing the charging process, the indicator flashes green. When the battery
charge-control indicator 6 lights up green continuously, the battery is fully
charged.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
1 609 92A 1ML | (25.11.15)
Bosch Power Tools