Intended Use; Safety; Mounting - Htronic WPS 1000 Bedienungsanleitung

1. Intended use

The intended use of the device is the detection of changes in water level with
the help of the accessory sensor. If the sensor comes in contact with water
the relay will switch and activate a warning signal, a solenoid valve or start a
pump. Any other use of the device is not permitted.

2. safety

When handling electrical devices using all valid VDE regulations must be ob-
served, in particular VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and
VDE 0860.
– Before opening the device, make sure that the device is disconnected from
the power supply.
– Tools may only be used on the device and/or its components, if the unit is
disconnected from the power supply and when any electric charge stored in
the components of the unit has been discharged.
– Cables and wires, with which components or device are connected, must
always be checked for insulation faults or fractures in the insulation.
– If a fault is found in the power cable, the device must immediately be deacti-
vated until the faulty cable has been replaced.
– When using components or modules the requirements, values and the descrip-
tion of these components for use are to be strictly followed.
– If, for a private user, the installation and the electrical requirements of the ex-
ternal components or accessories are not clear or understandable, or it Is not
clear which external devices can or may be connected to this device, consult
a trained expert for advice.
– Before installation and use, make sure that the device or module is the correct
device for the intended application and installation. If there is any doubt,
consult a trained expert or the manufacturer for advice
Please note that operation and connection errors are beyond our control. Liabi-
lity cannot be taken for consequential damages.

3. mountIng

The device may only be used indoors and in a dry environment. The device
has been designed for wall mounting and must be mounted in such a way, that
it cannot fall down. A correctly installed 230 V mains outlet must be installed
nearby the device.
14 | Mounting