Cleaning And Care; Information About Warranty And Service Processing - Parkside PABK 60 A1 Bedienungs- Und Sicherheitshinweise

... / Cleaning and care / Information about warranty and service processing
needle , as well as the thread adapter
12
into the barrel of the air blow gun
Universal valve connection
Screw the universal valve connection
onto the compressed air hose

Cleaning and care

Thoroughly clean the spray stylus
ately after use. Otherwise the paint can dry and
cause problems during the next use.
Thoroughly rinse out the spray stylus
water.
Use the thinner included to clean any stubborn
dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If you remove the paint nozzle of the
air blow gun during cleaning, lubricate the
9
threads before reattaching it so its freedom of
movement is not affected.
Never lay the entire air blow gun
vent bath.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.
Fault Interrupted paint jet
or intermittent paint
delivery
Cause Solution
1. Paint almost 1. Fill paint
empty
2. Paint too viscous 2. Lower viscosity
3. Dry / defective 3. Screw in nozzle tightly
nozzle or replace
4. Paint supply 4. Cleaning
restricted
5. Incorrect posi- 5. Correct position angle
tion of spray
stylus .
3
Fault
7
.
9
Cause
10
1. Air head
directly
10
dirty / defective
.
8
2. Nozzle dirty /
defective
Fault
immedi-
3
Cause
1. Defective nozzle 1. Replace nozzle. Contact
with
3
2. Paint too viscous 2. Lower viscosity
3. Insufficient
working pres-
sure
Fault
in a sol-
9
Cause
Nozzle dirty /
defective
Information about warranty
and service processing
Creative Marketing Consulting GmbH
warranty
Dear customer, the warranty for this device is 3 years
from the date of purchase. In the event the product
is defective, you have legal rights vis-à-vis the retailer
of this product. Your statutory rights are not limited
in any way by our warranty detailed below.
Spray pattern
incomplete
Solution
1. Clean / replace air head
1. Rinse with clear water
2. Clean / replace air
nozzle
Spray pattern irregu-
lar with drips
Solution
a respective service centre.
3. Increase working pres-
sure (if necessary, not in-
cluded accessories, e.g.
pressure reducer)
3. Hose defective; replace
hose
Non-uniform paint
amount delivered
Solution
Clean / replace air nozzle
GB 11