Using - Wetecom ET1058 Bedienungsanleitung

The initial setting displays the measuring units foot and inch. The first digit
stands for the measuring unit foot and the second digit for the unit inch.
Decide if you want to use inch or cm and press the shift key in/cm ( ).
Pressing the shift key
1x
2x
3x
4x
5x

Using

1. Set the measuring unit to cm by pressing the shift key in/cm (3) four
times.
2. Hook the hook of the tape on the object you want to measure and pull
the housing along the object.
3. On the display you will read the measured distance. If necessary, lock
the tape by pressing the tape lock button (7) firmly down. The tape will
lock in this position.
4. To retract the tape, press the tape retract button (8) down.
Using
Display
' ''
0 0
''
0
''
0,0
'
0,00
0,0
cm
' ''
0 0
10
Measuring Value in
Foot and Inch
(Initial Setting)
Inch
Inch in decimal value with
one decimal place after the
decimal point
Foot in decimal value with
two decimal places after the
decimal point
cm
Foot and Inch
(Initial Setting)