Inflating - Crivit Sl-1472 Bedienungsanleitung

avoiding Damage to the Product!
• All inflatable products are sensitive to the cold. The product should thus never be
unfolded and inflated at temperatures below 15° C!
• If air pressure increases in direct sunlight, it should be adjusted correspondingly by
releasing some of the air.
• Please ensure that the product – particularly when it is inflated – is not brought into
contact with stones, gravel or sharp objects and that it does not chafe or rub against
anything, as damages to the foil could otherwise occur.
• Only insert suitable pump adapters into the safety valves. Otherwise the valves could
become damaged.
• Do not inflate too strongly, as this could cause the welded seams to burst open.
Seal the valves tightly after inflating.
• Avoid contact with sharp, hot, pointed or dangerous objects.

Inflating

attentIOn!
• all air chambers must always be completely inflated!
• avoid excessively inflating the air chambers as this could cause the
welded seams to overstretch or even burst open.
• Use standard foot pumps or double-action hand pumps with the correct
adapters to inflate the product.
• Do not inflate the product with compressors or compressed air bottles.
this could damage the product.
• Make sure that the chambers are equally filled with air one after the
other.
• Only inflate the chambers enough such that they are still slightly wavy
on the inside after being inflated.
Inflate the air chambers in the following sequence:
1 – Headrest
2 – Headpiece
3 – Mid air chamber
4 – Foot piece
•
1. Valve headrest
•
2. Valve headpiece
•
3. Valve mid air
chamber
•
4. Valve foot piece
Fig. 1 Fig. 1
5