Product Overview - Stanley FatMax FMHT77356 Bedienungsanleitung

Compliance
This product complies with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to laser Notice
50, dated June 24, 2007.
Conforms to UL STDS 61010-1 & 2595
Certified to CSA STD C22.2 No. 61010-1

Product Overview

Figure A - Laser Tool
1. Laser Window/Aperture
2. Keypad Switch
3. Power/pendulum Lock Switch
4. DC Power supply jack
Figure B - Power /Transport Lock
5. Label
6. 1/4-20 and 5/8-11 threaded mount
Figure C - Keypad and Laser Modes
7. Battery/Power
8. Beam Activation Key
9. Pulse Mode Activation Key
10. Pulse Mode/Out of level indicator LED
Figure D - Beam Options
Figure E - Horizontal Beam Scan Direction Accuracy
Figure F - Horizontal Beam Pitch Direction Accuracy
Figure G - Vertical Beam Accuracy
Figure H - Vertical Beam 90° Accuracy
Keypad, Modes, and LED
Power /Pendulum Lock Switch (Fig B)
Power ON/Pendulum lock off /Self-leveling
On
Power OFF/Pendulum lock on
• To turn the laser tool ON move switch to the
unlocked position
• To turn the laser tool OFF, move switch to the locked
position
Modes
Laser Beam Available Modes.
See Figures C and D for beam configuration.
Self-Leveling (Fig B)
• The pendulum lock on the laser tool needs to be
switched to the unlocked /ON position to enable
self-leveling when placed in a position <4 °.
Out of Level (Fig B)
• If the laser has been tilted > 4° then it cannot
self-level and the laser beam will flash.
Keypad-Pulse key.
Pulse mode ON/OFF key
(See figure
Press to activate Pulse mode.
(See figure # 9)
Pulse Mode LED/Out-of-Level Indicator Operation
(See figure # 10)
LED OFF
1. Pulse Mode is OFF/ Unit is level
LED ON-CONTINUOUS GREEN
2. PULSE MODE is ON, and laser unit is within self-
leveling range. (<4 °)
LED ON-FLASHING RED
3. Laser unit is OUT OF LEVEL and beams will flash.
(PULSE MODE may be ON or OFF depending on
initial state set.)
Keypad-Battery key
Battery level indicator key
(See figure
Battery Life LED
(See figure # 7)
)
)
7