Error Signal; Display Fault Signal; Remove Fault Report - +Gf+ Ea 11 Betriebsanleitung

Electrical actuators type EA 11/ 21/ 31/ 42

8.4 Error signal

8.4.1 Display fault signal

In the case of a fault report
- the red LED 8 on the main board lights up. If the monitoring print is installed,
the particular LED lights up red on the BCD switch 10, if its set value is
exceeded.
- the ready to operate signal does not apply (terminal 5,6 no passage).

8.4.2 Remove fault report

 Check cause of fault
 If necessary, carry out relevant maintenance, see Section 10 fault repair
Repair the fault either while the supply voltage is still connected or while the
actuator is briefly disconnected from the mains voltage. (Not effective in cycle
monitoring).
 To repair, activate the reset switch 9 on motherboard.
Operation
57