Changing the Drive Belt
1. Unplug the mains lead from the wall socket.
2. Remove the 4 screws from the left side of the belt
cover and remove the cover.
3. Lift the belt tensioner and remove the drive belt from
the large pulley.
4. Install a new belt as shown in the picture,
turning the pulley until the belt sits into its groove.
5. Refit the belt cover and the 4 screws.
Troubleshooting guide
The snow blower does not start.
Snow does not exit the chute.
•
Make sure that the extension lead is connected correctly.
•
Check to see if there is power at the wall socket
•
Is the on/off button pushed in?
•
Is the safety lever pulled in against the handle?
•
Unplug the extension lead and make sure that the chute is not
clogged with snow.
9