Operation; Care And Maintenance - Cocraft DB5013 Bedienungsanleitung

Operation

Note: Knot the extension lead loosely around the middle of the handle
to prevent it from accidentally disconnecting during operation.
Starting
1. Make sure that the safety lever for the feed screw drive is released so the blower is in neutral.
2. Insert the ignition key. Make sure that it is pushed all the way in.
3. Connect an extension lead approved for outdoor use to the mains lead of the snow blower and to an earthed
wall socket.
4. Press and hold the on/off switch.
5. Pull the safety lever in towards the handle to start the feed screw. Release the on/off switch.
6. Release the safety lever to stop the feed screw.

Care and maintenance

• Always disconnect the mains lead from the power before servicing or adjusting the snow blower.
• Regularly check that all the nuts and bolts are tight and that the snow blower is undamaged and working properly.
• Ensure that any safety/warning labels are visible and legible. Replace any damaged or illegible labels.
• Always unplug the mains lead after use and before cleaning snow off the feed screw, impeller housing or
discharge chute.
• Store the snow blower in a dry, sheltered place out of the reach of children.
• Never store the snow blower with the mains lead plugged into a wall socket.
Changing the feed screw blades
1. Unplug the mains lead from the wall socket.
2. Undo the nuts and bolts and remove the rubber blades.
3. Replace the blades with new ones, refit the nuts and
bolts and tighten them.
Replacing the scraper blade
1. Unplug the mains lead from the wall socket.
2. Lay the snow blower handle down on the ground.
3. Detach the worn scraper by removing the 3 screws
holding it in place.
4. Screw the new scraper into place.
8