Ecler NEST106 Bedienungsanleitung Seite 7

Procedure for installing groups of several cabinets:
•
If you would like to install a set of two joined cabinets (1/4 sphere), you must first join their
two guides together using two screws, washers and nuts (supplied). Once you have joined
the guides, the installation procedure is basically the same as for an individual installation.
•
If you would like to install three or more cabinets jointed together, each of the guides
should be joined to the one prior to it using two screws, washers and nuts (supplied). Once
you have joined the guides, the installation procedure is basically the same as for an
individual installation.
•
If you would like to install a single front-facing cabinet on a flat surface, you must first
make a slight modification to the metal guide (it may be flattened to this end) and remove
the triangular tab next to the ECLER logo on the cabinet.
•
For other cabinets installations (on a flagpole, under a flagpole, etc.), contact our technical
support department or see www.ecler.com to check for available accessories and/or
recommendations for each particular case.
7