VOLTCRAFT PA-10 Bedienungsanleitung Seite 37

The battery type and current overall voltage
appear on the display. The word "Balancing"
flashes as well.
Press "OK" again to display the voltage values
for the individual cells. The upper line shows
cells 1-3 from the left to the right, the lower line
cells 4-6.
If all cells have the same voltage, the display
indicates "Balance END" and the Power Analyzer
emits 20 signal sound sequences.
Press OK to switch back to the previous display
or ESC to leave the balancer voltage display and
switch to the operating mode menu.
Error Messages during Balancing
If the voltage in one cell drops below the thresh-
old value set in the device, the display says
"CELL LOW VOL" and the Power Analyzer emits
acoustic warnings.
If the voltage of a cell is above the threshold
value set on the device, the DISPLAY says
"CELL HIGH VOL".
If a cable break or bad contact is present at the
battery's balancer plug the display says "CELL
CONNECT".
LiPo Check
LiPo Balance
LiPo-3S
Balancing
4.14 4.16
0.00 0.00
LiPo-3S
Balance END
LiPo-3S
CELL LOW VOL
LiPo-3S
CELL HIGH VOL
LiPo-2S
CELL CONNECT
12.457V
4.15
0.00
12.421V
Figure 11
8.520V
13.270V
9.310V
Figure 12
37