SEVERIN KB 2921 Gebrauchsanweisung Seite 12

plug into a suitable mains outlet.
∙ Set the selector switch to either the
cooling or the warming function. The
appropriate indicator light will come on.
∙ To compartmentalise the cool-box, the
partition may be inserted from above into
the 2 grooves on the inside.
∙ During periods of non-use, always switch
off the cool-box and disconnect the cable
last used from the power source.
Hints
Cooling
To achieve optimum cooling, the cool-box
should be fi lled with pre-chilled food and/or
beverages. The food and beverages will then
be kept cool or be cooled down even further.
With warm or non-chilled food and
beverages, the cooling process will take
considerably longer.
Keeping warm
Using the keep-warm function, food and
beverages may be kept warm. Again,
warming up cold food and beverages will
take some considerable time.
12V connection:
When the 12V cigarette lighter socket is
used to power the cool-box, it should not
be left connected for more than 2 hours
with the vehicle engine switched off. This
is to prevent the vehicle battery from
over-discharging. With the engine running,
the cool-box may be left connected for an
unlimited time.
Cleaning care and
∙ Before cleaning, remove the plug from the
wall socket and wait until the appliance
12
has completely cooled down.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ Do not use abrasives or harsh cleaning
solutions.
∙ The lid is removable for easy cleaning.
To remove, lift up the lid to its vertical
position and then pull it out of its hinges.
Replace the lid after cleaning.
∙ The lid may be wiped with a slightly moist
cloth.
∙ If necessary, the cool-box may be cleaned
with a moist cloth using a little mild
detergent. Wipe dry afterwards.
Troubleshooting
The cool-box is connected to a 12V power
source but does not work. In addition, the
electric fan is not turning.
∙ The 12V cigarette-lighter socket in your
vehicle only works with the ignition turned
on.
∙ The contact surfaces on the 12V
connecting plug may be dirty or corroded.
Clean them thoroughly.
∙ The voltage selector switch is not in the
correct position.
Disposal
This appliance has been
manufactured from recyclable
materials. The unit should be
disposed of through special waste
collection points in accordance with local
regulations. The chemical agent in the
insulation foam must be disposed of through
a competent agency.
Guarantee
This product is guaranteed against defects