Renkforce 1538778 Serviceanleitung Seite 19

15
• Carefully slide the nozzle throat into the extruder as
far as it will go ( ).
1
Make sure the side of the thermistor's protruding cable
s are facing to the front.
• Fasten the nozzle throat with the grub screw and
tighten it ( ).
2
17
• Secure the cables of the fan and the thermistor with
the cable tie (included in the delivery content).
• Use the side cutter to cut the cable binding end.
2
1
16
• Reconnect the plug.
The connector can only be connected in one direction.
18
• Attach the bracket to the heatsink using the screw.
Tighten the screw.
19