Intended Use; Delivery Content; Safety Instructions - Renkforce 1538778 Serviceanleitung

3. Intended use

This component replaces the thermistor with heater installed in the 3D printer RF100 (item no. 1507428). Replace the
thermistor, if the existing one is damaged.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product for purposes
other than those described above, the product may be damaged. In addition, improper use can cause hazards such as
short circuiting, fire, electric shock etc. Read the replacement and safety instructions carefully and keep them. Make
this product available to third parties only together with its replacement instructions.
This product complies with the statutory national and European requirements. All company names and product names
are trademarks of their respective owners. All rights reserved.

4. Delivery content

• Thermistor with heater
• 1,5 mm hex key
• Cable tie
• Saftey instructions
Up-to-date replacement instructions
Download the latest replacement instructions at www.conrad.com/downloads or scan the QR code
above. Follow the instructions on the website.

5. Safety instructions

Read the replacement instructions carefully and especially observe the safety instructions. If you
do not follow the safety instructions and information on proper handling in these instructions,
we assume no liability for any resulting personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous playing material
for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, vibrations, flammable gases,
steam, dust and solvent, high humidity, high moisture, such as rain or steam or strong mechanical strain.
14