Renkforce 1538778 Serviceanleitung Seite 18

11
• Remove both grub screws at the nozzle holder.
13
• Insert the new thermistor (1) into the large opening of
the nozzle holder (
1
Make sure that the end of the thermistor is aligned with
the nozzle holder.
• Insert the grub screw into the tapped hole and tighten
it ( ).
2
18
2
1
).
12
• Carefully pull the thermistor and the heating rod out of
the nozzle holder.
• Dispose the damaged thermistor with the heater.
14
• Insert the heating rod (2) into the small opening of the
nozzle holder ( ).
1
• Insert the grub screw into the tapped hole and tighten
it ( ).
2
2
1