Starting Up; Steam Cleaning; Topping Up The Boiler Water Tank With Water; After Use - Lavor KATLA Bedienungsanleitung

• 11 Do not use the appliance for steam cleaning
electrical appliances or electric sockets.
• 12 Once the appliance is plugged in, do not work
with wet hands or feet.
• 13 Do not immerse the appliance in any liquid.
• 14 Do not steam-clean the appliance.
• 15 Service and repairs must be carried out by
qualified personnel only. Only use manufacturer
original spare parts for service repair.
• 16 Before connecting the appliance, make sure
that the nameplate data are the same as those of
the electrical mains and that rhe socket is protect-
ed by a differential security breaker with tripping
sensitivity below 0.03 A - 30 ms.
• 17 Ensure that power sockets used ore correct for
the machine.
• 18 Never use the appliance in ambient
temperatures below 0°C if it is equipped with a
PVC (H VV-F) cable.
• 19 The electric cable must be replaced only by an
authorised service centre.
• 20 Do not vacuum explosive, toxic and
inflammable substances (e.g. chimney ashes and
soot) or substances that may be dangerous to
your health.
• 23 Do not place the suction orifice near delicate
parts of the body such as eyes, mouth and ears.
• 25 Never obstruct the steam outlet.
• 26 Do not point the steam jet towards people or
animals.
• 27 During use the appliance could overheat if
covered.
• 28 If the appliance is lent to someone else, the
instruction manual should also be passed on.
• 29 The appliance is not to be used by children or
persons with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowl-
edge, unless they have been given supervision or
instruction.
•
30 Children being supervised not to play with the
appliance.

STARTING UP

•
When preparing the appliance for use, switch
it off and unplug it!
- Fill the tank J with water (fig. 1)
• Do not put any kind of detergent or chemical
substance in the water tank!
- Fill the tank J with detergent (fig. 2)
1
- Put (◊,+, -,*) hose on (◊,+, -,*) hole on the tank
(fig. 3)
• This appliance is designed for use with the
detergent supplied or recommended by the
manufacturer. The use of other detergents or
chemicals may put the appliance's safety at
risk!
- Fit the nozzle H
1
connection H (fig. 4-5-6)
2

STEAM CLEANING

• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B
• Turn on the steam system using switch E and
wait until "steam ready" light D lights up.
• Selection with switch (P)
_ : INJECTION HOT WATER
: DRY STEAM
o
= : INJECTION DETERGENT
- To help the primer of the injection pump,
turn the steam tap F off and press the
switch L
3
- Pre-select the amount of steam using
the knob F located on the appliance. The
gauge R indicates the pressure inside the
boiler.
TOPPING UP THE BOILER WATER TANK WITH WA-
TER
• The boiler water tank L supplies the boiler
through an electronic level control; since this
is an external tank, it can be topped up any
time.
• When water runs out in the boiler water
tank:
1. the appliance beeps intermittently
2. the no-water level pilot light C flashes
3. the steam stops coming out
To top up, proceed as follows:
• Switch off the boiler switch E
• Turn off the main switch B
• Remove the cable from the socket
• Fill the boiler water tank J

AFTER USE

• Every time you finish working, put switch B, E
and P in OFF position.
• Extract the plug from the wall socket.
of the flexible hose L in the
EN
11