Seto CLIPLIGHT ONE Gebrauchsanleitung Seite 3

3. Ist die Leuchte angeschaltet, halten Sie die
An-/Aus-Taste gedrückt, um die Helligkeit zu
erhöhen. Drücken und halten Sie die Taste
noch einmal, um die Helligkeit zu verringern.
Die Leuchte flackert einmal, wenn die maxima-
le/minimale Helligkeitsstufe erreicht ist.
4. Ist die Leuchte angeschaltet, drücken Sie
kurz die Moduswechsel-Taste, um zwischen
drei verschiedenen Leuchtmodi zu wechseln
(Fokussiertes Licht > Streulicht (vorne) > Streu-
licht (oben))
5. Ist die Leuchte angeschaltet, drücken Sie die
Moduswechsel-Taste mindestens 2 Sekunden,
um in jedem Modus das SOS-Signal zu aktivie-
ren.
Reinigung und Pflege
Verwenden Sie zum Entfernen von Schmutz, Staub,
Öl, Fett usw. ein weiches Tuch, das mit einer milden
Seifenlösung oder Wasser leicht angefeuchtet ist.
Trocknen Sie mit einem weichen, trockenem Tuch
nach. Verwenden Sie zum Reinigen keine korrodie-
renden Substanzen oder Lösungsmittel.
Technische Daten
Typ SETO CLIPLIGHT ONE
Leuchtmittel LED TECHNOLOGIE
Farbtemperatur kaltweiß
Akku Li-Polymer 3,7V 400mAh
Ladezeit 1,5h
Abmessung 38,6 x 63,6 x 24,3mm
Gewicht 30g
Modellname CLP-300BK
Input USB 5V 1A
Attention
1. Blinding hazard! Never shine into someone's
eyes and do not look directly into the light. This
may lead to short- or even long-term eye dama-
ges (risk of retina damages).
2. Do not use the product for eye examinations
(pupil test). Increased blinding risk.
3. The outer housing of the luminaire can get warm
at intensive use. That is normal.
4. Do not use it near high temperature such as fire
or heating equipment. It may cause explosion
and ignition.
5. Do not use when it exceed the operating tempe-
rature range (-10°C to 40°C).
6. The battery is only to be used with the deli-
vered charger.
Warranty
1. After the battery is fully discharged, the battery
remaining indicator may not flash. If this hap-
pens, plug the USB cable back in or press the
button to the battery indicator again.
2. A warranty claim presupposes a correct hand-
ling; the warranty duration is 12 months after
purchase and refers to faulty parts or production
processes which make the product unusable. The
customer is not authorised to carry out repairs
on the luminaire. The producer or an authorised
distribution partner have to decide if the product
has to be repaired or replaced.
3. If the product is sent in for repair, it has to be
packed thoroughly, and the service retailer has
to be contacted. The respective invoice dcu-
ment (with purchase date) has to be in the
package. Sent in products without the respec-
tive document cannot be considered for the
manufacturer's warranty.
3. Damages, which are demonstrably causes by im-
proper handling, are excluded from the warranty.
Battery
Cautions for long-term storage
1. Keep 100% battery capacity when storing for a
long time.
2. Please keep in mind that if stored below 10
degrees Celsius, the battery life may be affected.
3. Please keep in a dry place without moisture.
3