Herunterladen Inhalt Inhalt Diese Seite drucken

Use And Maintenance; Veiligheidsvoorschriften - Tovenco Zilga Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

and respecting the distance from the ceiling indicated in Fig.2.
Connect the flange C to the air exhaust hole using a connec-
tion pipe (Fig.4). Insert the upper flue into the lower flue. Fix
the lower flue to the hood using the screws B provided (Fig.4),
extract the upper flue up to the bracket and fix it with the
screws B (Fig.3). To transform the hood from a ducting version
into a filtering version, ask your dealer for the charcoal filters
and follow the installation instructions.
• Filtering version
Install the hood and the two flues as described in the paragraph
for installation of the hood in ducting version. To assemble the
filtering flue refer to the instructions contained in the kit. If the
kit is not provided, order it from your dealer as accessory. The
filters must be applied to the suction unit positioned inside the
hood. They must be centred by turning them 90 degrees until
the stop catch is tripped (Fig.6).

USE AND MAINTENANCE

• We recommend that the cooker hood is switched on before
any food is cooked. We also recommend that the appliance is
left running for 15 minutes after the food is cooked, in order to
thoroughly eliminate all contaminated air. The effective perfor-
mance of the cooker hood depends on constant maintenance;
the anti-grease filter and the active carbon filter both require
special attention.
• The anti-grease filter is responsible retaining the grease
particles suspended in the air, therefore it is subject to clogging
with variable frequency according to the use of the appliance.
- To prevent the danger of possible fires, at least every 2
months one must wash the anti-grease filters by hand using
non-abrasive neutral liquid detergents or in the dishwasher at
low temperatures and on short cycles.
- After a few washes, colour alterations may occur. This does
not give the right to claim their replacement.
• The active carbon filters are used to purify the air that is sent
back into the room and its function s to mitigate the unpleasant
odours produced by cooking.
- The non-regenerable active carbon filters must be replaced
at least every 4 months. The saturation of the active charcoal
depends on the more or less prolonged use of the appliance,
on the type of kitchen and on the frequency with which anti-
grease filter is cleaned.
- Regenerable active charcoal filters must be washed by hand,
with non abrasive neutral detergents, or in the dishwasher at
a maximum temperature of 65°C (the washing cycle must be
complete without dishware). Remove excess water without
damaging the filter, remove the plastic parts, and let the mat dry
in the oven for at least 15 minutes approximately at a maximum
temperature of 100°C. To keep the regenerable charcoal filter
functioning efficient this operation must be repeated every 2
months. These must be replaced at least every 3 years or when
the mat is damaged.
• Before remounting the anti-grease filters and the regen-
erable active charcoal filters it is important that they are
completely dry.
• Clean the hood frequently, both internally and externally,
using a cloth dampened with denatured alcohol or neutral
liquid detergents that are non abrasive.
• The lighting .system is designed for use during cooking and
not for the prolonged general lighting of the room. The pro-
longed use of the lighting system significantly decreases the
average duration of the bulbs.
• If the appliance is equipped with courtesy lights it is possible
to use them for general room lighting for a prolonged amount
of time.
• Attention: the non compliance with the hood cleaning
warnings and with the replacement and cleaning of the filters
entails risk of fires. One therefore recommends keeping to the
suggested instructions.
• Replacing LED lamps (Fig.7):
If the appliance version is with LED lamps, the intervention of a
specialised technician is necessary to replace them.
• Commands (Fig.8):
Push-button A = On/off lights switch.
Push-button B = On/off cooker hood switch. The appliance
switches on at speed level 1, If the cooker hood is on depress
the push-button for 2 sec. to switch off the cooker hood. If
the cooker hood is at speed level 1 it will not be necessary
to depress the push-button to switch the cooker hood off.
Decreases the motor speed.
Display C = Indicates the motor speed level selected and
activates the timer.
Push-button D = Switches on the cooker hood. Increases the
motor speed. Touching the key at 3rd speed, the intensive
function runs for 10' , then the appliance go back to work at the
original speed. During this function the display blinks.
Key E = The Timer times the functions on activation for 15 min-
utes, after which they are switched off. The Timer is deactivated
by re-pressing Key E. When the Timer is activated the decimal
point must flash on the display. The Timer cannot be activated
if the intensive speed is functioning.
The "clean air" function is activated by pressing key E for 2
seconds when the appliance is switched off. This switches the
motor on for 10 minutes every hour at the first speed. During
functioning a rotary movement of the peripheral segments
must be visualised on the display. When this time has passed
the motor switches off and the fixed letter "C" must be visual-
ised on the display until the motor re-starts after 50 minutes
for another 10 minutes and so on. Press any key apart from
the light keys to return to normal functioning. Press key E to
deactivate the function.
• Active carbon/grease filter saturation:
- When display item C flashes, at a speed where it alternates with
the letter F (e.g. 1 and F), the grease filters must be washed.
- When display item C flashes, at a speed where it alternates
with the letter A (e.g. 1 and A), the active carbon filters must
be replaced or washed depending on the type of filter.
After the clean filter has been positioned correctly, the elec-
tronic memory must be reset by pressing button A for ap-
proximately 5 seconds, until the indication F or A shown on
the display C stops flashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE
WARNINGS.
NEDERLANDS
ALGEMEEN
Lees aandachtig de inhoud van deze handleiding. Hierin staan
belangrijke aanwijzingen voor een veilige installatie, gebruik
en onderhoud. Bewaar de handleiding om die later te kunnen
raadplegen. Het toestel werd ontworpen in een versie voor
afzuiging (evacuatie van de lucht naar buiten - Afb.1B) en voor
filtering (recirculatie van de lucht binnen - Afb.1A) .

VEILIGHEIDSVOORSCHRIFTEN

1. Opletten indien tegelijkertijd een afzuigkap en een brander
- 12 -
NL

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Barolo

Inhaltsverzeichnis