Connecting The Inputs - Conrad Electronic 30 32 54 Bedienungsanleitung

The following applies for all cinch connections:
• The white cinch jack on the mixing desk is the jack for the left channel.
• The red cinch jack on the mixing desk is the jack for the right channel.

Connecting the inputs

Inputs CHANNEL1 and CHANNEL2
These inputs are variable inputs which can be influenced by the respective input selection switches next
to the connection jacks. Depending on the switch position, these inputs can be used to connect a record
player or a CD player (or similar line device).
Before connecting, check the position of the respective selection switch. Set the
switch to the correct position. Before switching over, always switch off the mixer
at the mains switch.
Switch position CD
The PHONO switch position Record player with a magnetic system (this system is used by almost all
If your record players have their own earth (usually a thin, black cable with clamp-type
socket), connect this to the GROUND screw terminal. This helps to avoid buzzing and
interference.
A device with LINE level, e.g. CD player, MP3 player or radio, can be
connected to the appropriate input.
DJ record decks) can be connected to the respective input.
45