Safety Instructions - Conrad CDX-10 Bedienungsanleitung

4. Safety Instructions

In the case of damages which are caused due to failure to observe these operating instructions,
the guarantee will expire. We do not assume any liability for consequential damage!
Nor do we assume liability for damage to property or personal injury, caused by improper use
or a failure to observing the safety instructions. Any claim to warranty will lapse in such cases.
Dear customer, The safety instructions and danger warnings below are not only for the protection of the
device but also to protect your well being. Please read carefully through the following points:
• For safety and licensing (CE) reasons, unauthorised conversion and/or modifications to the product
are not permitted.
• All persons operating, installing, setting up, commissioning or servicing this device must be trained
and qualified correspondingly and observe these operating instructions.
• The device is designed according to protection class II. As source of voltage, only use a regular
mains socket (115 V~/60 Hz or 230 V~/50 Hz) of the public supply system.
• This product is equipped with a laser (class 1). Never open the device! A laser label is affixed to the
device to caution the users. Do not remove the warning sign from the appliance. Do not open up the
appliance or attempt to reach any interior components. Never look directly into the laser beam. Laser
radiation can seriously damage your eyes.
• Please see that you operate the appliance properly. Please also follow these operating instructions.
• Make sure the mains cable is not squashed, bent, damaged through sharp edges or otherwise
subjected to mechanical strain. Avoid excess thermal stress on the mains cable through excess heat
or cold. Do not modify the mains cable. This may damage the mains cable. A damaged power cord
can result in a life-threatening electric shock.
• If the cables show damages, do not touch them. First of all, de-energize the corresponding mains
socket (e.g. via the respective circuit-breaker) and afterwards carefully pull the mains plug from the
socket. Separate the mains cable from the device. Never use the product if the power line is
damaged.
• In order to completely separate the device from the electricity net, you have to pull the mains plug
of the CD player out of the wall socket. It is not sufficient to turn the CD player off with the on/off switch.
26
Class 1 Laser