i) Programming and playing a track sequence
You can save track sequences of up to 20 tracks.
Programming track playlist
•
Stop CD playback by pressing the PLAY/PAUSE button (11).
•
Press the button PGM (6). The display shows „P-01" (program spot 1).
•
With the track jump buttons (12 or 15) or the keypad (1), select the first desired track.
•
Press the button PGM (6). The display shows „P-02" (program spot 2).
•
With the track jump buttons (12 or 15) or the keypad (1), select the next desired track.
•
Continue until the desired track sequence is programmed.
Playing back the programmed track sequence
•
Start playback of the programmed track sequence by pressing the key PLAY/PAUSE (11).
•
With the button SINGLE/CONT (7), switch the CD player to „CONTINUE" mode (CONTINUE appears on the
display), otherwise the CD player always goes into pause at the start of a new track.
Checking a programmed track playlist
•
To check a programmed track sequence, you have to stop playback by pressing the button PLAY/PAUSE (11).
•
Then you can skip through the programmed tracks by pressing the button PGM (6).
Quitting the track sequence playback function
•
To quit playback of the track sequence, interrupt playback with the button PLAY/PAUSE (11).
•
Remove the CD from the CD compartment or turn the CD player off.
•
The track sequence is deleted.
k) Turning the player off
•
Interrupt CD playback by pressing the PLAY/PAUSE button (11).
•
Open the CD compartment by pressing OPEN/CLOSE (3) and take out the CD.
•
Close the CD compartment by pressing OPEN/CLOSE (3).
•
Turn off the amplifier and/or mixing desks that might be connected.
•
Only then switch off the CD payer with the mains switch (24).
39