f) Cueing
You can select the starting point for playback using the CUE-function. The start point is set automatically (AUTO
CUE).
The advantage of this function is that e.g. empty slots at the start of a title are not played back and that
there are therefore no breaks after starting the playback.
Auto CUE
•
After pressing a track jump button (12 or 15) or a keypad button (1), the device automatically sets the CUE point
in the position where the music starts.
Back CUE
•
During playback, press the button CUE (10).
•
The CD player jumps to the start of the track or to the saved CUE point and enters into pause mode.
Checking the CUE-mark
•
Press the CUE button (10).
•
The device returns to the CUE point and goes into pause mode.
•
Press and hold the CUE button (10).
•
Playback starts from the CUE point as long as you keep the CUE (10) button depressed.
•
After letting go, the CD player returns to the CUE mark and switches to the pause mode.
Deleting a CUE point
•
The CUE-mark is deleted as soon as a new CUE mark is set.
g) LOOP-function (playback looping)
You can define a playback loop. The start and end point of the loop is set during playback.
•
At the desired start point of the playback loop, press the button IN (8).
•
At the desired end point of the playback loop, press the button OUT (16).
•
The playback loop is now played back continuously until the button OUT (16) is pressed again.
•
To call up a saved playback loop again, press the button RELOOP (17).
The existing playback loop is deleted when a new playback loop is programmed.
37