Monacor DAC-199 Bedienungsanleitung Seite 14

GB into operation. The new code number may consist of
up to 8 digits and must at least be 3 digits long.
1) Type existing code number, i. e. 135246, of fac-
tory.
2) Press key
digits). Press key
If your own code number is to be changed, repeat
items 1) and 2).
Attention! If the power supply to the keypad control-
ler is interrupted or the reset key (S1) is pressed
during test operation, the code number 135246 is
activated again.
6.2 Activate the alarm center
Type the code number and then press the key
6.3 Deactivate the alarm center
Enter the code number and press the key
alarm centers which need a permanent contact for
the control, the key
tivating. If the correct code number is entered, this is
confirmed by a beep tone of several times and the
alarm center is deactivated.
If a wrong code number has successively been
entered for three times, it must be waited for 60
seconds until it is possible to try again. After nine
attempts of entering a wrong code number, in case of
corresponding connection an alarm can be released.
14
and type new code number (3 to 8
again.
need not be pressed for deac-
.
. With