Adjustment Of The Dip Switches; Operation - Monacor DAC-199 Bedienungsanleitung

resistors integrated in the keypad controller must be
short-circuited. For this the contact spots J3 (for the
red LED) and J4 (for the green LED) are each
bridged with a soldering point.

5 Adjustment of the DIP switches

If the connected alarm center requires a permanent
contact for activating, all 3 DIP switches (S2) have to
be set to ON.
If the alarm center requires a short switching-on
resp. switching-off pulse, the operating time of the relay
is adjusted according to the following list. If the keypad
controller is used as a door opener, the time of the ope-
ning procedure is adjusted with the DIP switches.
DIP switch (S2)
1
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF

6 Operation

Every key pressing is confirmed with a beep sound,
the yellow LED shortly lights up.
6.1 Changing of the code number
The code number 135246 is adjusted in the factory.
Replace this number by your own code while setting
Operating time of the relay
2 3
ON permanent contact
OFF
OFF
OFF
OFF
ON 15.0 sec
ON 30.0 sec
0.5 sec
1.0 sec
2.5 sec
5.0 sec
GB
13