Technaxx Nature Wild Cam TX-69 Gebrauchsanleitung Seite 20

 Take Photos: Press Capture button to switch to photo mode. Press Shot
button to take a picture.
 Record Video: Press Video button to switch to video mode. Press Shot
button to start to record a video clip. Press Shot button again to stop
recording.
 Playback: Press Playback button (10) to enter the playback interface.
Press Up/Down button to scroll through photos or videos. When you want to
playback video, press OK button to play the video. Press OK button again to
have a pause. Press Menu button to stop playback. Press Playback button (10)
again to exit the playback mode. Under "Playback" press the Menu button 
Select from the following options:
Delete the current
photo or video
Delete all files
Activate slide show
Write protect
Working Mode
 Switch the Mode Button to "On". After turn on the camera, the screen will
display 15 seconds countdown. Then the LEDs and screen will go out. The
camera begins to operate independently and enter standby mode.
 If the wild animals enter the detection range of the motion sensors, the
camera will be activated and detect the motion trail. If the wild animals
continue to move to the detection zone of the sensor, the camera will take
photos or record video automatically.
 When the wild animals leave the detection zone of the sensors, the camera
will be deactivated and turn back to standby mode.
Delete all photo and video
files saved on the memory
card.
Playback the photos in
slide way.
 Press OK button to stop playing.
Lock the file. It can avoid
accident deletion.
 Select and press OK button to confirm.
Options: [Cancel] / [Delete]
 Press OK to confirm
Options: [Cancel] / [Delete]
 Press OK to confirm
Each photo display 3 sec.
Options:
current file] / [Write-protect
all files] / [Unlock current file]
/ [Unlock all files].
8
[Write-protect