Technaxx Nature Wild Cam TX-69 Gebrauchsanleitung Seite 17

Sensitivity Motion Sensors options: [Low] / [Middle] (default) / [High].
 Select and press OK button to confirm.
Test the sensitivity and find the correct detection zone for your purpose. Set
the sensitivity of the sensor. Note: The temperature can also influence the
sensor sensitivity.
Set the sensitivity to low if you want to record indoors (small
Low
environment) or in cold environment.
Set the sensitivity to middle if you want to record outdoor (normal
Middle
environment).
Set the sensitivity to high if you want to record outdoors (huge
High
environment) or the temperature is mild.
Target Recording Time
Set the target recording time of the
day. With this
preselect when recordings should
been taken.
As shown in below picture, you can
set the start and stop time. The
camera will work just in the set time
slot. In other time, the camera will
keep in standby state.
Options: [On] / [Off] (default).
Note: If start time and stop time are the same,the working time is 24 hours.
Time Lapse Recording
Set the interval time of taking
pictures. The
pictures automatically as per set time
interval. For example, set the interval
time to 1 hour, the camera will take a
photo each hour. If you want to
observe that a plant blooms, the
camera will take 24 photos in 24
hours to record the whole process of
blooming.
Options: [On] / [Off] (default).
option you
camera will take
Set
can
Target recording time
Start：
Hr： Min Hr： Min
00 00 00 00
MENU Back OK Select
 Select and press OK to confirm.
Settings
Set time lapse
Hr： Min ： Sec
Notification:Motion
sensors deactivated
MENU Back OK Select
 Select and press OK to confirm.
5
Stop：
00 00 30