Fein 7 221 50 Handbuch Seite 14

3 41 01 118 06 0.book Seite 14 Mittwoch, 27. August 2008 10:20 10
en
Instruction manual for angle polisher.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Observe the instructions in the text or graphic opposite!
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Be absolutely sure to read the enclosed documentation such as the Instruction Manual and the
General Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
An exposed surface is very hot if touched and therefore dangerous.
Additional information.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Confirms the conformity of the power tool with the directives of the European Community.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Ø Diameter of a round part
Ø =maximum backing pad diameter
D
Ø
D
M=Thread for clamping flange
M
l=Length of mounting thread
l
Weight according to EPTA-Procedure 01/2003
Low speed
High speed
14