Deleting Measured Values - Bosch GLM 50 C Professional Originalbetriebsanleitung

OBJ_BUCH-2450-001.book Page 41 Wednesday, April 29, 2015 9:07 AM
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 36.
Press the button 3 [+]. The calculated area and the symbol "+" will be
displayed.
50.039 m 2
0.0° +93.406 m
2
Press the measuring button 2 [
Measure the area as described in section "Area Measurement", see
143.45 m
2
page 36. Once the second measurement is completed, the result of the
second area measurement is displayed below.To show the end result,
press the measurement button 2 [
Note: With a length measurement, the end result is displayed immediately.
To exit addition, press button 7 [Func].
Subtracting Values
To subtract values, press button 8 [–]. The subsequent steps are the same as for
"Adding Values".

Deleting Measured Values

Briefly pressing the On/Off button 5 [
measuring functions. Repeated brief pressing of the On/Off button 5 [
the measured values in reverse order.
Changing the Unit of Measure
Unit of measure "m" (metres) is set by default.
Switch the measuring tool on.
Press and hold button 7 [Func], to enter the "basic configurations" menu. Select "ft/m".
Press button 3 [+] or button 8 [–], to change the unit of measure.
Press the On/Off button 5 [
saved after you switch off the measuring tool.
Bluetooth® Interface
Data Transmission to other Devices
The measuring tool is equipped with a Bluetooth® module, which enables data trans-
mission via radio technology to certain mobile terminals/devices with a Bluetooth® in-
terface (e.g., smartphones, tablets).
Bosch Power Tools
] to start another area measurement.
] once more.
] will delete the last measured value in all
] to exit the menu item. The selected setting remains
English | 41
] will delete
2 609 141 257 | (29.4.15)