Bosch GLM 50 C Professional Originalbetriebsanleitung Seite 36

OBJ_BUCH-2450-001.book Page 36 Wednesday, April 29, 2015 9:07 AM
36 | English
To measure, briefly press the measuring button 2 [
shown at the bottom of the display.
Repeat the above-mentioned steps for each subsequent measurement.
The last measured value is at the bottom of the display, the penultimate
7.620 m
measured value is above it, and so on.
0.0° 8.890 m
10.160 m
11.430 m
Continuous Measurement (Tracking)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
Select the continuous measurement
To switch on the laser beam, briefly press the measuring button 2 [
Move the measuring tool until the required distance value is indicated in the bottom
of the display.
Briefly pressing the measuring button 2 [
ous measurement. The current measured value will be shown at the bot-
1.291 m
min
tom of the display. The maximum and minimum measured value appear
-64°
11.623 m
max
above it. Pressing the measuring button 2 [
11.623 m
continuous measurement.
Continuous measurement automatically switches off after 5 mins.
Area Measurement
Select the area measurement
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance
to be measured flashes in the indicator for area measurement
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area will be au-
tomatically calculated and displayed. The end result is shown at the bot-
0.0°
3.810 m
5.080 m
tom of the display, while the individual measured values are shown
19.355 m
2
above it.
2 609 141 257 | (29.4.15)
]. The measured value will be
.
], interrupts the continu-
.
].
] once more, restarts the
.
Bosch Power Tools